Black plate (146,1)
qOperating the Radio
Channel preset buttons
Band selector buttons Display
Manual tuning dial
Auto memory button
Seek tuning buttons
Traffic information button
Channel preset buttons
Radio ON
Press a band selector button (
, or
) to turn the radio on.
Band selection
Select a band by pressing the FM1 button
(
), FM2 button ( ) or AM button
(
).
The selected mode will be indicated. If
FM stereo is being received, “ST” will be
displayed.
NOTE
If the FM broadcast signal becomes
weak, reception automatically changes
from STEREO to MONO for reduced
noise, and the “ST” indicator will go
out.
Tuning
The radio has the following tuning
methods: Manual, Seek, Scan, Preset
channel, and Auto memory tuning. The
easiest way to tune stations is to set them
on preset channels.
NOTE
If the power supply is interrupt ed (fuse
blows or the battery is disconnected),
the preset channels will be erased .
Manual tuning
Turning the manual tuning dial will
change the frequency higher or lower.
6-24
Interior Comfort
Audio System
RANGER_F8M1-10-08I_Edition1 Page146
Friday, September 26 2008 3:6 PM
Form No.F8M1-10-08I
To Next Page
Loading...
