Black plate (182,1)
Jumper leads
Booster battery
Discharged battery
Connect leads in numerical order and disconnect in reverse order.
1. Make sure the booster battery is 12 V
and that its negative terminal is
grounded.
2. If the booster battery is in another
vehicle, don't allow both vehicles to
touch. Turn off the engine of the
vehicle with the booster battery and all
unnecessary electrical loads in both
vehicles.
3. Connect the jumper leads in the exact
sequence as in the illustration.
l
Connect one end of a lead to the
positive terminal on the discharged
battery (1).
l
Attach the other end to the positive
terminal on the booster battery (2).
l
Connect one end of the other lead to
the negative terminal of the booster
battery (3).
l
Connect the other end to a solid,
stationary, exposed metallic point
(for example, the engine hanger)
away from the discharged battery
(4).
4. Start the engine of the booster vehicle
and run it a few minutes. Then start the
engine of the other vehicle.
5. When finished, carefully disconnect the
leads in the reverse order described in
the illustration.
7-18
In Case of an Emergency
Emergency Starting
RANGER_F8M1-10-08I_Edition1 Page182
Friday, September 26 2008 3:7 PM
Form No.F8M1-10-08I
To Next Page
Loading...
