Ford Ranger 2008 - Page 230

Black plate (230,1)
qCavity Protection
Cavities are treated for protection at the
factory, but additional prote ctive treatment
after the vehicle has been put into use will
extend the life of the body.
We recommend that you consult an expert
repairer, we recommend an Authorised
Ford Repairer concern ing this additional
precaution.
qBright-Metal Maintenance
l
Use tar remover to remove road tar and
insects. Never do this with a knife or
similar tool.
l
To prevent corrosion on bright-metal
surfaces, apply wax or chrome
preservative and rub it to a high lustre.
l
During cold weather or in coastal areas,
cover bright-metal parts with a coating
of wax or preservative heavier than
usual. It would also help to coat them
with noncorrosive petroleum jelly or
some other protective compound.
CAUTION
Don't use steel wool, abrasive cleaners,
or strong detergents containing highly
alkaline or caustic agents on chrome-
plated or anodised aluminium parts.
This may result in damage to the
protective coating and cause
discolouration or paint deterioration.
qUndercoating
This special coating is applied to the
critical parts of the underside to protect
vehicles from damage caused by
chemicals or stone s. This coating is liable
to be damaged with time. Check this
coating periodically.
An expert repairer, we recommend an
Authorised Ford Repairer are well
informed on how repairs should be made.
Consult an expert repairer, we recommend
an Authorised Ford Repairer.
qAluminium Wheel Maintenance
A protective coating is provided over the
aluminium wheels. Special care is needed
to protect this coating.
NOTE
l
Do not use a wire brush or any
abrasive cleaner, polishing
compound, or solvent on aluminium
wheels. They may damage the
coating.
l
Only use a mild soap or neutral
detergent and always use a sponge or
soft clot h to clean the wheels.
Rinse thoroughly with lukewarm or
cold water. Also, be sure to clean the
wheels after driving on dusty or
salted roads. This helps prevent
corrosion.
l
Avoid washing your vehicle in an
automatic car wash that uses high-
speed or hard brushes.
l
If your aluminium wheels lose lustre,
wax the wheels.
8-44
Maintenance and Care
Appearance Care
RANGER_F8M1-10-08I_Edition1 Page230
Friday, September 26 2008 3:7 PM
Form No.F8M1-10-08I