1.6 Jacking
WARNINGS:
Always position the vehicle on a hard
level surface. If the vehicle must be jacked
up on a soft surface use load spreading
blocks under the jack. Always chock the
wheel diagonally opposite the jacking
point. Failure to follow these instructions
may result in personal injury.
Do not get under a vehicle that is
supported by a jack.
This jack is only intended for changing
wheels.
CAUTIONS:
It is important that only the correct
jacking and support locations are used at
all times.
Make sure that access to the spare wheel
is maintained when converting the vehicle
or relocating the spare wheel.
NOTE: When using the vehicle jack, refer to the
owner guide for correct operating instructions.
NOTE: Make sure that reinforcements are installed
to maintain the integrity of the original body
structure for/at jacking points.
NOTE: Any modifications to the vehicle must be
noted in the owner's handbook or new descriptive
literature included with the owner's
documentation.
The spare wheel winch is located above the spare
wheel and can be accessed from the rear of the
chassis frame.
The jack must be assembled and fixed
appropriately to the body to ensure safety,
durability and accessibility.
1. Ensure screwthread is adequately lubricated
before use.
2. The jack should be used on level firm ground
wherever possible.
3. Apply park brake fully before lifting the vehicle.
4. It is recommended that the wheels of the
vehicle should be chocked, and no person
should remain in a vehicle being jacked.
5. No person should place any portion of their
body under a vehicle that is supported by a jack.
All Vehicles
To Next Page
Loading...
