Instructions for connection
1. The vehicle speed output is available on:
[connector 3 pin number 52] or [connector 4
pin 3]. Choose one of the connections and
populate the connector with a terminal and
wire.
2. The output must be connected to a device with
1k ohms resistance (600 ohms to 2k ohms is
the guideline) in order for it to work. This
protects the BCM (body control module) from
overcurrent risk.
3. The output must be connected to a power
source.
4. Once the device is connected, reset the BCM
by disconnecting the vehicle battery.
5. Reconnect the vehicle battery.
6. Turn the ignition ON.
7. The signal should now be available.
NOTE: Rload should be present and connected
to battery voltage for this function to work.
For Information Only
Terminal part number: 96AG-14474-RSA.
Wire size and color: 0.5 CSA, blue - green.
Terminal Insertion
1. Connector C3 or C4 need to be unplugged in
order to insert the speed signal terminal.
2. Once the connector C3 or C4 is removed, the
grey cap needs to be removed by first removing
the cable tie, and then levering up the two
detents on the sides; the cap can then be slid
off.
FORD RANGER 2012
Date of Publication: 12/2014
4 Electrical
48
To Next Page
Loading...
