Note: When the blower is in AUTO mode,
no blower setting indicators will be
illuminated.
When the blower speed is controlled
manually by operationg the blower dial,
the blower setting is indicated in the
display above the air distribution controls.
To return to auto mode, short press the
AUTO button.
Temperature control
You can set the temperature between 16°C
(61°F) and 28°C (82°F) in steps of 0.5°C
(1°F). In position LO (below 16°C (61°F))
the system will switch to permanent
cooling, in HI (above 28°C (82°F)) to
permanent heating, and not regulate a
stable temperature.
Mono Mode
In Mono mode the temperature settings
for both the driver’s and passenger’s side
are linked. If you adjust the temperature
using the rotary control on the driver’ s side,
the settings will be adjusted to the same
setting on the passenger’s side.
To switch dual mode on
Long press of the AUTO button or
selecting the temperature for the
passenger’ s side with the rotary control on
the passenger’s side. The temperature for
the driver’s side will remain unchanged.
You can now adjust the driver and
passenger side temperatures
independently. The temperature settings
for each side are shown in the display. You
can set a temperature difference of up to
4°C (8°F).
Note: If you set a temperature difference
of greater than 4°C (8°F), the temperature
on the other side will be adjusted so that
the difference remains 4°C (8°F).
To switch dual mode off
Press the AUTO button for three seconds
or select HI or LO on the driver's side. The
passenger’s side temperature will be
adjusted to the driver’s side temperature.
68
Ranger (TKE) Vehicles Built From: 01-12-2014, DB39-120609-JB enAUS, First Printing
Climate Control
To Next Page
Loading...
