4.1.3 Auxiliary Battery Relocation and
use of Electrical Harness Extension
(Fly Lead) (XL Plus Vehicles)
WARNING: Make sure all electrical
connections and wiring comply with
regulations stated in ADR 42/04 Clause
9.
An Electrical Harness Extension (fly lead) may
be required when the auxiliary battery is being
relocated from the temporary battery carrier. The
fly lead is required to connect the auxiliary battery
wiring harness to the 16-pin connector on the
vehicle wiring harness. This allows the operation
of auxiliary battery powered accessories from the
dash mounted switch panel within the vehicle
cabin.
The electrical harness extension is available in
two lengths:
• Single Cab Chassis: 1850 mm
• Double Cab Chassis: 1390 mm
When used on a vehicle fitted with an aluminium
load tray, the electrical harness extension is fitted
in the shown orientation:
Electrical Harness Extension (Fly Lead)
DescriptionItem
Electrical Harness Extension (fly lead)1
Connection to the vehicle harness2
Connection to the auxiliary wiring harness3
4.1.4 Generator and Alternator
Alternator Current Output
See your local authorised dealer to identify the
alternator output current specifications for your
vehicle.
4.1.5 Authorised Parts
The following authorised parts available at your
authorised Ford Dealer.
Part NumberDescription
AB39-14B475-MAASecondary Battery Harness - Double Cab
AB39-14B475-MBASecondary Battery Harness - Single Cab
4S7T-14489-VKA12 Way In-Line Switch Connector (IP Harness End)
4S7T-14A459-VKAIP Switch Panel
Date of Publication: 02/2017
FORD RANGER 2015
To Next Page
Loading...
