Ford Ranger 2015 - Roof Racks

Bull Bar Accessory Mounting Positions
DescriptionItem
Aerials, antennas and flag mounting location1
Driving lights mounting location2
Antenna Cables Routing
WARNINGS:
Ensure that the antenna cables have
sufficient clearance from hot and moving
parts.
Do not fasten the antenna cables to
original vehicle wiring, fuel pipes and
brake pipes.
Keep the antenna and power cables at
least 100mm from any electronic
modules and airbags and associated
wiring.
NOTE: Make sure the sealing integrity is
maintained to avoid water ingress into the cabin
while routing the cables through the grommet.
Antenna cables should be routed from the engine
bay into the cabin area through the existing
grommet. There is a service nib provided on the
grommet.
Refer to Exterior lighting - Additional external
lamps for driving lights cable routing.
5.1.8 Roof Racks
Roof racks may be fitted to all variants as
illustrated in figure, providing the following is
satisfied:
• The carried load does not exceed 80kg (Body
Builder to ensure owner’s hand book identifies
this limitation).
• The carried load does not exceed 300mm load
height (converter to ensure owner’s
information book identifies this limitation).
• The load is evenly distributed (converter to
ensure owner’s information book identifies this
limitation).
• The rack and subsequent carried load is
supported in the roof drip rails irrespective of
rack retaining method.
Date of Publication: 02/2017
FORD RANGER 2015