1/8/2019 2019 Ranger
http://www.fordtechservice.dealerconnection.com/vdirs/protech/global/default.asp?bbcollection=BB_MOTORCRAFT 3/4
Lifting Points – Front and Rear
NOTE: 4WD shown, RWD similar.
WARNING: Position the hoist lift arms as shown in the illustration. Incorrect positioning could result in
vehicle slipping or falling from the hoist. Failure to follow this instruction may result in serious personal injury.
Only the specified jacking points may be used for jacking and supporting the vehicle.
NOTICE: The jack provided with the vehicle is intended to be used in an emergency for changing a deflated tire.
To avoid damage to the vehicle, never use the jack to hoist the vehicle for any other purpose.
NOTICE: Do not attempt to use jack pressure on either the front bumper or the rear bumper on any vehicle.
Damage to bumper covers will occur.
NOTICE: Place blocks underneath the lifting points if a two-column hoist is used.
NOTICE: Damage to the suspension, exhaust or steering linkage components may occur if care is not
exercised when positioning the hoist adapters prior to lifting the vehicle.
NOTICE: To prevent possible damage to the underbody, do not drive the vehicle onto the drive-on lift without
first checking for possible interference.
NOTICE: When raising a vehicle on a two-column hoist, use care when positioning the vehicle so that the
hoisting forks do not interfere with suspension components, mounting brackets or stabilizer mounting
brackets, if equipped. In addition, use care in hoist positioning to avoid possible damage to the axle or rear
cover.
Copyright © 2019 Ford Motor Company
To Next Page
Loading...
