Ford Ranger 2020 - Fuel Filler Vent Hose

Clearance From Vehicle Body
A
E145835
DescriptionItem
At least 9mm clearance between the fuel filler cap and vehicle body, in the worst case opening
angle if applicable
A
3.2.3 Fuel Filler Vent Hose
• The fuel tank vent hose and breather cap
should be rerouted from the shipped position
to the position described in this document in
order to maintain water wading specifications
and prevent water ingress into the fuel system.
• The supplied fuel tank breather cap must be
used.
• A length of fuel grade flexible hose should be
clipped to the vehicle body, with the open end
at least 600 mm (4x2) or 800 mm (4x4 or 4x2
hi-rider) above ground height. It is
recommended to measure this height when
the vehicle is fully loaded.
• The fuel tank vent hose should be protected
and positioned away from direct water spray,
wheel splash and mud splash, and water
drainage holes that may be present.
• The fuel tank vent hose breather cap must be
upright with its arrow pointing UP.
Fuel Filler Vent Breather Cap
E212453
NOTE: See your Authorised Ford Dealer to confirm
the correct part number for your vehicle.
Date of Publication: 09/2020
FORD RANGER 2020
3 Powertrain
47