Example of Fuel Tank Vent Hose Mounting Location
DescriptionItem
Front Lower Head Board of a Load Tray (load tray rotated for clarity)1
Fuel Tank Vent Hose2
3.2.4 Axle Breather Vent Hose
The rear differential breather hose should be
mounted to the filler neck/vehicle body. Where
required due to the fitment of an auxiliary body,
aftermarket additions, or the relocation of the fuel
filler, the axle vent hose routing must follow the
relocated fuel tank venting. A length of fuel grade
flexible hose should be clipped to the vehicle body,
with the open end at least 600 mm (4x2) or 800
mm (4x4 or 4x2 hi-rider) above ground height. It
is recommended to measure this height when the
vehicle is fully loaded. A vent breather cap may be
used on the axle breather vent hose.
3.2.5 Selective Catalytic Reduction
System
WARNINGS:
The engine may not start if you tamper
with or disable the selective catalytic
reduction system.
The engine may not start if the Diesel
Exhaust Fluid (AdBlue
®
) level is low.
Make sure it is refilled.
The engine may not start if the Diesel
Exhaust Fluid (AdBlue
®
) is contaminated.
Replace the contaminated fluid
immediately.
The use and refilling of Diesel Exhaust
Fluid (AdBlue
®
) is mandatory for the
vehicle to comply with the legal emission
requirements.
The Selective Catalytic Reduction System helps
to reduce exhaust emission levels by injecting
Diesel Exhaust Fluid (AdBlue
®
) into the exhaust
system. For proper functioning of this system make
sure you refill the Diesel Exhaust Fluid (AdBlue
®
)
periodically.
NOTE: The Selective Catalytic Reduction system
is only fitted to vehicles with a style side box.
NOTE: If removing or replacing the load box ensure
the filler hose angle and clearances of both the
fuel filler and Diesel Exhaust Fluid (AdBlue
®
) filler
are maintained.
NOTE: Refer to the vehicle owner manual for
further information on the Selective Catalytic
Reduction System.
FORD RANGER 2020
Date of Publication: 09/2020
3 Powertrain
48
To Next Page
Loading...
