• Re-paint metal edges after cutting or drilling.
All metal edges must comply with exterior and
interior protection legislation.
• All fixings through the floor, sides or roof must
be sealed.
Refer to: 5.4 Corrosion Prevention (page 87).
• Ensure that any additional equipment in the
vicinity of the fuel tank will not damage the
tank in a crash condition.
For any conversion structure attached to or
mounted onto the base vehicle cab structure the
following applies:
• Ensure that neither the conversion structure
nor the existing vehicle structure get
pre-loaded by the assembly process.
• Adhesive jointing is recommended but should
be supplemented with mechanical fasteners
to prevent initial peel and long term failure.
• Spread bolt loads to minimize local stress.
Body Attachment Holes in Chassis Frame - Single cab
C
E
F
N
M
H
G
K
L
C
D
E
F
M
L
H
G
J
K
A
B
N
P
E134152
C
E
F
N
M
H
G
K
L
C
D
E
F
M
L
H
G
J
K
A
B
N
P
E134152
Dimensions (mm) for Body Attachment Holes in Chassis Frame - Single Cab
1086H16A
95J28B
768K23C
893L20D
509M1244E
26N1244F
20P1244G
Date of Publication: 09/2020
FORD RANGER 2020
5 Body and Paint
73
To Next Page
Loading...
