Roof Rack Vehicle Converter Special Fit - Ranger Raptor
1
4
3
2
E393361
DescriptionItem
Rear edge of front attachment point1
80kg (Dynamic) (Maximum) / 350kg (Static) (Maximum)2
Maximum roof rack length: within length of drain channel3
Maximum load height 300mm4
5.1.10 Cargo Management on Vehicle
Tub
WARNING: Only use the recommended
attachment points, otherwise damage
may occur to the load box.
CAUTIONS:
Canopy weight and canopy load should
pass through the recommended
structural attachment points.
A minimum clearance of 28mm between
the vehicle cab and any fitted service
body, canopy, tray or load management
structure must be maintained to prevent
damage to the vehicle cab structure
during operation.
Ranger vehicles built with a cargo "tub" are
pre-equipped with mounting positions in the tub
side rail to allow the fitment of upfitter cargo
solutions such as canopies, sports bars, carry
racks etc.
NOTE: Side rail attachment points using M8
threaded fasteners must not be tightened to a
torque higher than 25Nm.
Refer to the vehicle's owner manual for
information related to factory fit cargo
management.
Refer to: 1.10 (page 30).
Load Box Reinforcement Brackets
WARNING: Make sure that all cargo loads
are properly balanced and secured.
CAUTION: To support the structural
integrity of the load box when a canopy
is fitted, Ford recommends the
installation of load box reinforcement
brackets. Load box reinforcement
brackets are available as a Ford Licenced
Accessory.
Date of Publication: 06/2022
FORD RANGER 2022
Composed on:Thu Oct 13 04:01:02 BST 2022
5 Body and Paint
129
To Next Page
Loading...
