E377014
X
DescriptionItem
Maximum Body Width: 1910 mmX
1.9.6 Worldwide Harmonized
Light-Duty Vehicle Test Procedures
(WLTP) Calculation Inputs
The following attributes are required as part of
the WLTP calculation for completed vehicles
Mass of the Completed Vehicle
All modifications and changes that effect the
actual mass of the vehicle must be taken into
account. The definition of actual mass is
described under the provisions of regulation
2018/1832 Annex XXI. The actual mass of the
completed vehicle needs to be provided for the
front and rear axle. This weight split will be
important where the completed vehicle has mixed
tires between the front and rear.
Frontal Surface Area
All modifications and changes that effect the
frontal surface area of the completed vehicle
must be taken into account. For further
information please see information later in this
section.
Tire Rolling Resistance
Any changes in tires fitted to the completed
vehicle must be taken into account. The efficiency
class and tire class is needed to determine the
correct calculation. This can be found on the tire
label as per the example below.
Date of Publication: 06/2022
FORD RANGER 2022
Composed on:Thu Oct 13 04:01:01 BST 2022
1 General Information
21
To Next Page
Loading...
