E309537
Exceeding Attribute Limits
As a requirement of the Vehicle Converter to use
the base vehicle approval, the Vehicle Converter
must stay within the defined limits of the BEMM
and the Emissions Type Approval applicable to
the vehicle. It is the responsibility of the Vehicle
Converter to ensure they stay within these defined
limits to remain compliant with the emissions
performance. If the Vehicle Converter wishes to
exceed the limits they must seek clarification with
the relevant technical service or type approval
authority. In this case, the base approval may
become invalid and the Vehicle Converter may
need to re-certify the vehicle against the exceeded
limits.
1.9.7 Worldwide Harmonized
Light-Duty Vehicle Test Procedures
(WLTP) Calculation Inputs - Raptor
The following attributes are required as part of the
WLTP calculation for completed vehicles
Mass of the Completed Vehicle
All modifications and changes that effect the
actual mass of the vehicle must be taken into
account. The definition of actual mass is described
under the provisions of regulation 2018/1832 Annex
XXI. The actual mass of the completed vehicle
needs to be provided for the front and rear axle.
This weight split will be important where the
completed vehicle has mixed tires between the
front and rear.
Frontal Surface Area
All modifications and changes that effect the
frontal surface area of the completed vehicle must
be taken into account. For further information
please see information later in this section.
Tire Rolling Resistance
Any changes in tires fitted to the completed vehicle
must be taken into account. The efficiency class
and tire class is needed to determine the correct
calculation. This can be found on the tire label as
per the example below.
E309537
Exceeding Attribute Limits
As a requirement of the Vehicle Converter to use
the base vehicle approval, the Vehicle Converter
must stay within the defined limits of the BEMM
and the Emissions Type Approval applicable to
the vehicle. It is the responsibility of the Vehicle
Converter to ensure they stay within these defined
limits to remain compliant with the emissions
performance. If the Vehicle Converter wishes to
exceed the limits they must seek clarification with
the relevant technical service or type approval
authority. In this case, the base approval may
become invalid and the Vehicle Converter may
need to re-certify the vehicle against the exceeded
limits.
1.9.8 Vehicle Dimensions Key
FORD RANGER 2022
Date of Publication: 06/2022
Composed on:Thu Oct 13 04:01:01 BST 2022
1 General Information
22
To Next Page
Loading...
