Dimensions - not to exceed for Chassis Cab body Length
Dimension (mm)Description
Double CabSuper CabSingle Cab
1518mm1816mm2286mm
Frame length behind back of cab (not including rear
light cross-member)
A
Under run bar and towing attachment legislation to be maintainedB
2400 over the top of frame, provided load
distribution requirements are met
Maximum recommended external body height *C
497mm795mm1265mmFront outside of body to rear axle centre lineD
(50% of vehicle wheelbase), provided
load distribution requirements are met
Maximum recommended rear overhangE
28mm MinimumClearance between the back of the cab and the bodyF
Ensure local lighting legislation is maintained. Refer to: 4.6 Exterior Lighting (page 85).G
30mmClearance between the top of the cab and the bodyH
1910Maximum external body width (without side step)J
*
For WLTP markets this dimensions should be disregarded. Refer to the relevant WLTP dimensions.
Refer to: 1.9 Package and Ergonomics (page 19).
All dimensions (shown in mm) are subject to manufacturing tolerances and refer to min specification
models which do not include additional equipment. The illustrations are for guidance only.
1.10.2 Recommended Body
Dimensions - Raptor
WARNINGS:
Do not modify the wheelbase or add any
type of frame extension to vehicles fitted
with Electronic Stability Program (ESP).
Ensure that any mass added to the vehicle
does not compromise vehicle stability.
NOTE: Extreme rear overhang may encourage
unacceptable loading conditions, which could
unload the front axle, producing unacceptable
handling and braking characteristics. Ensure that
the center of gravity of the body and payload does
not fall outside of the recommended zone.
NOTE: An excessively high center of gravity could
reduce vehicle stability. Ensure that the center of
gravity of the body and payload does not fall
outside of the recommended zone.
NOTE: When extending the length of the frame
rearward of the rear axle, it is recommended that
the overall rear overhang is limited to a maximum
of 50% of the wheelbase of the vehicle.
NOTE: If a towball is fitted to the vehicle, the body
dimensions must incorporate a towball clearance
zone in accordance with local regulatory
requirements.
If a conversion requires more than 50% overhang,
please contact your local National Sales Company
representative, or Local Ford Dealer.
Load carrying structures should not be mounted
onto an existing load tray or load box. Body
attachment points are provided on the frame.
Refer to: 5.1 Body (page 109).
FORD RANGER 2022
Date of Publication: 06/2022
Composed on:Thu Oct 13 04:01:01 BST 2022
1 General Information
32
To Next Page
Loading...
