Ford Ranger 2022 - Fuel Filler Mounting - Raptor

Fuel Filler Height - Cab Chassis Vehicles
E363646
A
A
DescriptionItem
A filler neck opening height of at least 250mm should be maintained, measured from the fuel
tank ICV opening centre point to the fuel filler pipe opening centre point.
A
3.2.3 Fuel Filler Mounting - Raptor
CAUTIONS:
Make sure that the filler neck mounting
bracket is made of a conductive material,
and that it provides a grounding path for
the fuel filler neck.
Maintain capless filler neck mounting
location exactly per factory installed
filler pipe position. Capless filler inlet
must be located inside a filler pocket.
Routing of the fuel filler pipe must ensure
no contact with any exhaust components
or sharp edges.
No kinking of the fuel filler hose is
acceptable.
NOTE: Routing of filler hose and vent hose must
not contain any sumps. Additional support may
be required to prevent hose sagging which could
create a sump. A sump in the pipe can cause spray
or spit-back during normal filling operations.
If the vehicle body and mounting bracket does
not provide a grounding path for the fuel filler
neck, an earth strap must be added, connecting
the filler neck to the chassis frame.
Do not extend the fuel filler system outboard of
the vehicle dimensions or the service body
dimensions.
Date of Publication: 06/2022
FORD RANGER 2022
Composed on:Thu Oct 13 04:01:01 BST 2022
3 Powertrain
61