NOTE: See your authorised dealer to confirm the
correct part number for your vehicle.
Example of Fuel Tank Vent Hose Mounting Location
E376759
2
1
DescriptionItem
Front Lower Head Board of a Load Tray (load tray rotated for clarity)1
Fuel Tank Vent Hose affixed securely.2
3.2.5 Long Range Fuel Tanks
NOTE: Long Range Fuel Tanks are not engineered
by Ford Motor Company and Ford Motor Company
makes no determination as to the fit, finish,
quality, safety or durability of these parts.
NOTE: Whilst functionality will be improved by
this modification, distance to empty calculations
may express some discrepancy compared to
standard parts and calculations.
Following installation of a long range fuel tank,
distance to empty (DTE) functionality will be
reduced.
To improve system functionality, using FDRS
(Ford Diagnosis and Repair System) as
appropriate:
• Plug FDRS into vehicle
• Allow FDRS to read parameters and show
applicable menus
• In Configuration Parameter; Select Fuel Tank
Capacity Volume (Tank Size A);
• Select appropriate option following the
dialogue selections: Fuel Tank Capacity >
Configuration Description
– Standard 80L
– 120L Long Range Tank
– 140L Long Range Tank
3.2.6 Axle Breather Vent Hose
The rear differential breather hose should be
mounted to the filler neck/vehicle body. Where
required due to the fitment of an auxiliary body,
aftermarket additions, or the relocation of the fuel
filler, the axle vent hose routing must follow the
relocated fuel tank venting. A length of fuel grade
flexible hose should be clipped to the vehicle
body, with the open end at least 600 mm (4x2)
or 800 mm (4x4 or 4x2 hi-rider) above ground
height. It is recommended to measure this height
when the vehicle is fully loaded. A vent breather
cap may be used on the axle breather vent hose.
Date of Publication: 06/2022
FORD RANGER 2022
Composed on:Thu Oct 13 04:01:01 BST 2022
3 Powertrain
63
To Next Page
Loading...
