3.2.7 Axle Breather Vent Hose - Raptor
The rear differential breather hose should be
mounted to the filler neck/vehicle body. Where
required due to the fitment of an auxiliary body,
aftermarket additions, or the relocation of the fuel
filler, the axle vent hose routing must follow the
relocated fuel tank venting. A length of fuel grade
flexible hose should be clipped to the vehicle body,
with the open end at least 800 mm above ground
height. It is recommended to measure this height
when the vehicle is fully loaded. A vent breather
cap may be used on the axle breather vent hose.
FORD RANGER 2022
Date of Publication: 06/2022
Composed on:Thu Oct 13 04:01:01 BST 2022
3 Powertrain
64
To Next Page
Loading...
