Level 2 - Mid Level Headlamps - High Beam Connection
E375900
CAUTION: Connection of auxiliary loads
directly to Level 2 headlamp high beam
wiring is not allowable. Damage to the
headlamp control components may
result.
NOTE: Right Hand Drive vehicle shown, Left Hand
Drive vehicle similar.
Connection of auxiliary loads triggered by the Level
2 headlamp high beam being switched on is via a
pre-installed blunt cut wire located in the
passenger foot well, behind the kick panel on the
main harness. A blunt cut wire will be tagged to
suit such a connection.
FORD RANGER 2022
Date of Publication: 06/2022
Composed on:Thu Oct 13 04:01:02 BST 2022
4 Electrical
92
To Next Page
Loading...
