E364606
2
5
1
6
3
4
2
1
DescriptionItem
BCM Connector C51
BCM Connector C62
RH Rear Turn Signal Output = BCM Connector C5 Pin 523
LH Rear Turn Signal Output = BCM Connector C5 Pin 264
RH Front Turn Signal Output = BCM Connector C6 Pin 385
LH Front Turn Signal Output = BCM Connector C6 Pin 396
4.6.11 Electrically Operated Door
Mirrors
WARNING: Do not tamper with the base
system (controlled by Central Junction
Box and multiplex architecture) and any
feeds taken from the associated wiring
or controller.
NOTE: These options are not suitable for
aftermarket or converter modification.
4.6.12 Centre High Mount Stop Lamp
(CHMSL)
NOTE: When replacing the factory fitted CHMSL
with a canopy mounted CHMSL, the same type
must be used. Replace a bulb/incandescent type
only with a bulb/incandescent. Replace an LED
type only with an LED type.
NOTE: The maximum current load that can be
applied to the CHMSL circuit is 2.5A for either
incandescent globes or LED lamps. Do not exceed
the rated load.
Centre High Mount Stop Lamp (CHMSL) usage
must comply with ECE R48-04 or local
regulations.
When installing a canopy equipped with a CHMSL,
a feed for the CHMSL can be taken from the BCM
(Connector 5 Pin 13).
4.6.13 Automatic High Beam Control
NOTE: The automatic high beam control feature
will not function, or performance may be degraded
if any conversion or installation is in the field of
view of the front camera.
NOTE: The automatic high beam control feature
will not function, or performance may be degraded
if the vehicles ride height is increased, or
decreased, or if the pitch of vehicle is modified.
Be aware, when no headlamp switch Auto
Position is available (or Auto is not selected on
the original switch), auto high beam control
(provided with forward vision camera) will not be
available or shown in the cluster.
Date of Publication: 06/2022
FORD RANGER 2022
Composed on:Thu Oct 13 04:01:02 BST 2022
4 Electrical
97
To Next Page
Loading...
