• No lane markings are detected.
• One or both rear radar sensors become
blocked or faulty.
• You have not configured the attached
trailer correctly in the trailer tow menus
or you attached an unsupported trailer.
The system only supports certain trailer
shapes and dimensions.
Note: Blind spot assist with trailer coverage
could have reduced performance if any of
the above limitations are present.
Blind spot assist may have difficulty
detecting hazards under the following
conditions:
• If a vehicle is approaching in an
adjacent lane at a relative speed much
higher than your vehicle.
• Bad weather conditions are present
that obstruct the sensors.
• Attaching bike or cargo racks could
cause false alerts due to obstruction
of the sensor.
BLIND SPOT ASSIST WITH
TRAILER COVERAGE INDICATORS
Diagram 1: Vehicle A uses its left turn
signal preparing to change from the right
lane to the middle lane. Vehicle B is already
in the middle lane and just entered Vehicle
A's blind spot causing the blind spot
information system alert indicator to flash
on the exterior mirror.
Diagram 2: The driver of Vehicle A begins
to steer into the center lane not aware of
Vehicle B.
Diagram 3: Blind spot assist counter
steers to help alert the driver of Vehicle A
to direct their vehicle back into the right
lane to help avoid a possible collision with
Vehicle B.
The lane keeping aid warning lamp or
yellow lane marking in your instrument
cluster display indicate blind spot assist
activation. In addition, the blind spot
information system alert indicator flashes
on the exterior mirror on the same side as
the detection. See Blind Spot
Information System (page 301).
297
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Lane Keeping System
To Next Page
Loading...
