1. Park your vehicle directly in front of a
wall or screen on a level surface,
approximately 35 ft (10 m) away.
2. Measure height from the center of the
low beam to the ground and, from this
measurement, deduct 4 in (10cm) and
add a reference line 15 ft (4.5 m) wide
on vertical wall or screen at this height.
A piece of masking tape works well.
3. Switch on the low beam headlamps to
illuminate the wall or screen and open
the hood. Cover one of the headlamps
so no light hits the wall.
4. On the wall or screen, observe a light
pattern with a distinct horizontal edge
toward the right. If this edge is not at
the horizontal reference line, adjust the
beam so the edge is at the same height
as the horizontal reference line.
5. Locate the vertical adjuster on each
headlamp. Use a screwdriver to turn
the adjuster either counterclockwise
or clockwise to adjust the vertical aim
of the headlamp.
6. Repeat Steps 3 through 7 to adjust the
other headlamp.
7. Close the hood and switch off the
headlamps.
Horizontal Aim Adjustment
Horizontal aim is not required for this
vehicle and is not adjustable.
EXTERIOR BULBS
EXTERIOR BULB SPECIFICATION
CHART
Replacement bulbs are specified in the
chart below. The correct bulbs will not
damage the lamp assembly or void the
lamp assembly warranty and provide
quality bulb illumination time.
Power (Watt)SpecificationLamp
LEDLEDCenter high mounted cargo lamp.
Vehicles with pickup box.
Low Series - 21WLow Series - H18Daytime running lamp (If equipped).
417
2024 Ranger (TRD) Canada/United States of America, enUSA, Edition date: 202304, DOM
Maintenance
To Next Page
Loading...
