Roadside Emergencies
239
%
*
[ER25100(R)02/96]
Preparing Your Vehicle
*
[ER25200(R)02/96] 1. Your vehicle has a 12-volt starting system, so you need to
use a 12-volt jumper system. You will damage your starting
motor, ignition system, and other electrical parts if you
connect them to a 24-volt power supply (either two 12-volt
batteries in series or a 24-volt generator set).
*
[ER25300(R)02/96] 2. Do not disconnect the battery of the disabled vehicle. You
could damage the vehicle’s electrical system.
*
[ER25400(R)02/96] 3. Park the booster vehicle close to the hood of the disabled
vehicle. Make sure the vehicles do not touch each other. Set
the parking brake on both vehicles and stay clear of the
engine cooling fan and other moving parts.
*
[ER25500(R)02/96] 4. Check all battery terminals and remove any excessive
corrosion before you attach the jumper cables.
*
[ER25600(R)02/96] 5. Turn on the heater fan in both vehicles. Turning on the fan
helps protect the electrical system from voltage surges. Turn
off all other switches and lights in both vehicles to prevent
possible damage to either vehicle’s electrical systems.
%
*
[ER25700(R)02/96]
Connecting the jumper cables
*
[ER25800(R)02/96] 1. Connect one end of the first jumper cable to the positive (+)
terminal of the discharged battery. (You can connect either
jumper cable to the positive (+) terminal, as long as you use
the same cable for both positive terminals.) Most jumper
cables have a red cable and a black cable. The red cable is
generally used for the positive terminals and the black for
the negative ones.
*
[ER25900(R)02/96] 2. Connect the other end of the first cable to the positive (+)
terminal of the booster battery.
*
[ER26000(R)02/96] 3. Connect one end of the second cable to the negative (s)
terminal of the booster battery — NOT to the discharged
battery.
File:10unerr.ex
Update:Thu Mar 20 08:56:46 1997
To Next Page
Loading...
Need help?
General
