Roadside Emergencies
241
*
[ER26800(R)02/96] 3. When both vehicles are running, let them idle for a few
minutes to charge the discharged battery.
%
*
[ER26900(R)02/96]
Removing jumper cables
*
[ER26910(R)02/96] 1. Always remove the jumper cables in the reverse order.
Remove the negative (s) end of the jumper cable from the
metallic surface on the engine or frame of the disabled
vehicle.
*
[ER26920(R)03/96] 2. Remove the negative (s) cable from the booster battery.
*
[ER26922(R)02/96] 3. Remove the positive (+) cable from the booster battery.
*
[ER26924(R)02/96] 4. Remove the other end of the positive (+) cable from the
discharged battery.
*
[ER26926(R)02/96]
After the vehicle is started, let it idle for a while to let the
engine “relearn” its idle conditions. Drive it around for a while
with all electrical accessories turned off to let the battery
recharge. Driveability may be deteriorated slightly until all drive
modes are “relearned.” You may need to use a battery charger
to fully recharge the battery.
*
[ER26928(R)03/96]
If you need to replace your battery, see Battery in the
Maintenance and Care chapter.
File:10unerr.ex
Update:Thu Mar 20 08:56:46 1997
To Next Page
Loading...
Need help?
General
