You can use the power point for powering
electrical devices that require up to 150
watts. It is on the rear of the center
console.
The power point indicator light, located on
the power point, shows when the power
point is ready for use.
When the power point indicator light is:
• On — the power point is ready to supply
power.
• Off — the power point power supply is
off and so is the ignition.
• Flashing — the power point is in fault
mode, or the battery voltage is to low.
The power outlet temporarily turns off
power when in fault mode if the device
exceeds the 150 watt limit. Unplug your
device and switch the ignition off. Switch
the ignition back on, but do not plug your
device back in. Let the system cool off and
switch the ignition off to reset the fault
mode. Switch the ignition back on and
make sure the indicator light remains on.
Do not use the power point for certain
electric devices, including:
• Cathode-ray, tube-type televisions.
• Motor loads, such as vacuum cleaners,
electric saws and other electric power
tools or compressor-driven
refrigerators.
• Measuring devices, which process
precise data, such as medical
equipment or measuring equipment.
• Other appliances requiring an
extremely stable power supply such as
microcomputer-controlled electric
blankets or touch-sensor lamps.
108
Ranger (), EB3B-19G219-ZAB enAUS
Auxiliary Power Points
To Next Page
Loading...
