•
The functions Program 1 and
Program 2 allow you to
programme up to two heating
times for each day of the week.
These times will remain stored
and the heater will warm up the
vehicle at these times on these
days every week.
•
The function One-Time allows
you to programme one heating
time for one specific day.
•
The function Active now
switches on the heater directly.
Programming the functions
Program 1 and Program 2
1.
Highlight Program 1 and press
the right arrow button.
2. Highlight the day on which the
heater should warm up the
vehicle.
3.
Press the OK button to confirm
the selection. A cross appears in
the box next to the day to show
that this day is selected.
4. Continue in the same way to
select all the days on which the
heater should warm up the
vehicle.
5. To set the time at which the
vehicle should be warmed up,
highlight the time at the top of the
display and press the right arrow
button.
6.
Press the OK button and the
hours flash. Use the up and down
arrow buttons to adjust the
individual settings and the left and
right arrow buttons to move to the
next or previous setting.
7. When you have finished, press the
OK button again to confirm the
settings.
You can use the function Program
2 to set a second time, for example
different times on different days or
two times on the same day. The
programming procedure is the same
as for the function Program 1.
124
Climate control
To Next Page
Loading...
