Note:
When fitting the headlamp,
make sure that you reconnect the
electrical connector properly.
Note:
When fitting the headlamp,
make sure that you fully engage the
headlamp in the lower fixing point.
Note:
When fitting the headlamp,
place the front screw into the
headlamp unit before you install it.
Tighten the front screw first and then
the rear screw.
CHANGING A BULB
WARNINGS
Switch off the lights and the
ignition.
Let the bulb cool down before
removing it.
Have Xenon bulbs changed by
a trained technician. There is a
risk of electric shock.
CAUTIONS
Do not touch the glass of the
bulb.
Only fit bulbs of the correct
specification. See Bulb
specification chart (page 75).
Headlamp
Direction indicatorA
Headlamp main beamB
Headlamp dipped beamC
Cornering lampD
Remove the covers to gain access
to the headlamp and cornering lamp
bulbs.
Direction indicator
1. Remove the headlamp. See
Removing a headlamp (page
62).
To Next Page
Loading...
