1. Fold the seatbacks down. See
Rear seats (page 129).
2. If the retention net is folded, press
the red release button C on the
hinges of the upper and lower bar
1 and unfold it.
3. Push the ends of the upper bar
towards each other and insert
them into the retainers on the roof
A or B. Make sure that the flap for
the centre seat belt is situated on
the right hand side of the vehicle.
4. Push the bar forwards into the
narrow section of the retainers 2.
5. Attach the net to the luggage
anchor points 3. See Luggage
anchor points (page 181).
6.
Tighten the belts 4.
Remove in the reverse order.
If you need to use the centre seat
belt:
1.
Open the flap 5.
2. Route the seat belt through the
opening.
Luggage retention net -
type 2
CAUTIONS
Do not exceed the maximum
permissible retention net load of
1 kilogram (2 pounds).
Do not place large objects in the
lower net storage
compartments.
Make sure that the rods are
securely positioned in the trim
panels.
187
Load carrying
To Next Page
Loading...
