Up to four different driver's seat and
exterior mirror positions can be stored in
the memory. Your preferred setting for the
reverse mirror dipping feature can also be
stored.
Setting a memory pre-set
Passive setting
The vehicle stores the seating and mirror
positions for up to four remote controls or
passive keys. Next time the vehicle is
unlocked, the position of the seat and
mirrors will adjust to the last used position.
Each time you turn the ignition off, the
current seat and mirror settings are stored
on the remote control or passive key used.
Active setting
1. Turn the ignition on.
2. Adjust the seat and exterior mirrors to
the desired position.
3. Press and hold the desired pre-set
button B until a single chime sounds to
confirm.
Recalling a stored seat position
Note: To stop seat movement during a
recall, press any driver seat adjustment
control, any of the memory buttons or any
mirror control switch. Seat movement will
also stop if you move the vehicle.
Passive recall
Note: If more than one passive key is in
range, the memory function will move to the
settings of the first key stored.
When you unlock the vehicle with the
remote control or pull the driver door handle
with a passive key in range, the seat and
mirrors will move to the position stored on
that remote control or passive key.
Active recall
Press the pre-set button associated with
the desired driving position. The seat and
mirrors will move to the position stored on
that pre-set.
Resetting the memory
If any seat position travel is interrupted (e.g.
an obstacle in the way or loss of power
supply), you will need to reset the memory.
Note: Make sure all electrical accessories
are switched off.
1. Turn the ignition to position II.
2. Operate the seat adjustment control to
move the seat in the required direction
until it stops. A click will be heard.
3. Release the seat adjustment control
and immediately press and hold the
switch in the same direction for at least
3 seconds. Keep it held until the seat
stops at the mechanical end of its travel
and a click is heard.
4. Release the seat adjustment control.
5. Operate the same seat adjustment
control in the opposite direction for at
least 3 seconds. Keep it held until the
seat stops at the mechanical end of its
travel and a click is heard.
KEYLESS STARTING
Ignition On
Press the button once without your foot on
the brake or clutch pedal.
Note: The keyless starting system may not
function if the passive key is close to metal
objects or electronic devices such as mobile
phones.
Starting with Manual Transmission
1. Fully depress the clutch pedal.
2. Press the start button.
10
To Next Page
Loading...
