The drive mode control is on the
instrument panel.
Press the four-wheel drive mode button
that best fits the current driving conditions.
You can select two-wheel drive high (2H)
or four-wheel drive high (4H) at a stop or
while driving. When the shift is complete,
the mode you select appears in the
instrument cluster display. While shifting,
the lights on the drive mode control can
flash and you could see messages in the
instrument cluster display indicating that
a shift is in progress or to release the
accelerator pedal to improve shift
performance.
Note: Momentarily releasing the accelerator
pedal while a shift in progress message
displays improves engagement or
disengagement performance.
Note: Do not perform this operation when
cruise control or trail control is selected and
active. The system may not shift as
expected.
Note: When the light is solid, the system
has achieved the desired four-wheel drive
mode. When a selected four-wheel drive
mode light is blinking, the system is
attempting to shift to that specific
four-wheel drive mode.
Note: When you achieve recreational
towing, all lights are off and Neutral Tow
Enabled Leave Transmission in Neutral
appears in the instrument cluster display.
Note: Do not perform this operation if the
rear wheels are slipping, when making a
tight turn or when applying the accelerator
pedal. The system may not shift as
expected.
Note: In certain scenarios, where the
four-wheel drive system has difficulty
engaging, a To Engage 4x4 Slow to 3 MPH
or To Engage 4x4 Slow to 5 km/h
message could appear in the instrument
cluster.
Note: You could hear some noise as the
system shifts or engages, this is normal.
If the system detects a fault, a warning
message appears in the instrument cluster
display. See Four-Wheel Drive –
Information Messages (page 239).
Shifting to or from Four-Wheel
Drive Low (4L)
To select or exit four-wheel drive low (4L):
1. Bring your vehicle to a speed of 3 mph
(5 km/h) or less.
2. Place the transmission in neutral (N)
3. Press the desired four-wheel drive
button on the drive mode control.
A message appears in the instrument
cluster display indicating a four-wheel
drive shift is in progress. If any of the above
shift conditions are not present, the shift
will not occur and information guiding you
through the proper shifting procedures
appears in the instrument cluster display.
237
2024 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202307, DOM
Four-Wheel Drive (If Equipped)
To Next Page
Loading...
