Ford SUPER DUTY 2024 - Integrated Trailer Brake Controller - Troubleshooting

INTEGRATED TRAILER BRAKE CONTROLLER –
TROUBLESHOOTING
INTEGRATED TRAILER BRAKE CONTROLLER – INFORMATION
MESSAGES
DetailsMessage
The system detects a correct trailer
connection during a given ignition cycle.
Trailer Connected
The system detects the trailer wiring
connection is disconnected during a given
ignition cycle.
Trailer Disconnected
The system detects an electrical fault in
the trailer brake circuit. If this message
appears without a trailer attached, see your
authorized dealer. If a trailer is attached,
inspect and repair the trailer wiring.
Trailer Wiring Fault
Displays the current gain setting for the
trailer brake.
Trailer Brake Gain: {trailer gain value:#0.0}
Displays the current gain setting for the
trailer brake when you do not have a trailer
connected.
Trailer Brake Gain: {trailer gain value:#0.0}
No Trailer
The vehicle's battery voltage is low or there
is a fault with your trailer's battery. Your
trailer's battery voltage is below 8 volts or
it is connected in reverse polarity.
Trailer Battery Not Charging See Manual
Perform a trailer brake and trailer light
check if possible. If the message persists,
have your vehicle checked as soon as
possible.
Trailer Brake Module Fault
Verify the trailer brake connections are
secure and that the aftermarket trailer
brake controller device is correctly installed.
Perform a trailer brake and trailer light
check if possible. If the message persists,
have your vehicle checked as soon as
possible.
Trailer brake system fault See manual
372
2024 Super Duty (TFH) Canada/United States of America, enUSA, Edition date: 202307, DOM
Integrated Trailer Brake Controller