Doors and Locks
The system will not function if:
• Your vehicle battery has no charge.
• The passive key frequencies are
jammed.
• The passive key battery is flat.
Note:
If the system does not function,
you
will need to use the key blade to lock
and
unlock your vehicle.
The system allows you to operate your
vehicle without the use of a key or remote
control.
Locking and unlocking requires a valid
intelligent access key to be located within
one of the there external detection ranges.
These are located approximately 1 m from
the front door handles and from the swing
gate handle. You can also use the
Intelligent Access key as a remote
control. See Locking and Unlocking
(page 30).
Locking Using Intelligent Access
Touch the outer door handle lock sensor
for approximately one second to lock,
being careful to not touch the unlock
sensor on the back of the door handle at
the same time. After locking, you can
immediately pull on the door handle to
confirm locking occurred without
inadvertently unlocking.
Note:
Your vehicle does not lock itself
automatically. If you do not lock, your
vehicle will remain unlocked.
Note:
Locking touch surfaces are
located
on each of the front doors.
For central locking and to arm the alarm:
• Touch the locking surface once.
After locking the doors with the lock
sensor, there is a brief delay before you can
unlock your vehicle.
This delay lets you pull the handle to make
sure your vehicle is locked.
Note:
When the delay period is over, you
can open the doors again, provided the
Intelligent Access is within the respective
detection range.
Two short flashes of the direction
indicators confirms that all the doors and
swing gate have been locked and that the
alarm (if equipped) has been armed.
Unlocking Using Intelligent Access
33
Territory (CF4) Philippines, Vehicles Built From: 25-05-2020, EN, First Printing
To Next Page
Loading...
