Doors and Locks
Note:
Your vehicle remains locked for
longer than three days, the system will
enter
an energy-saving mode.
This is to
reduce
the discharge of your vehicle
battery. When
your vehicle is unlocked
while in this mode,
the reaction time of
the system may be a
little longer than
normal. To exit the
energy-saving mode,
unlock your vehicle.
With your intelligent access key within 1 m
of your vehicle, touch the unlock sensor on
the back of the door handle for a brief
period and then pull on the door handle to
unlock, being careful to not touch the lock
sensor at the same time or pulling the door
handle too quickly. The intelligent access
system requires a brief delay to
authenticate your intelligent access key
fob.
Note:
Keep the door handle clean to
make
sure the system operates correctly.
Note:
A valid passive key must be
located
within the detection range of that
door.
One long flash of the direction indicators
confirms that all the doors and swing gate
have been unlocked and that the alarm (if
equipped) has been disarmed.
Unlocking only Driver Door
If the unlocking function is reprogrammed
so that only the driver door is unlocked. See
Remote Control (page 27). Note the
following:
If the driver door is the first door which is
unlocked, the other doors and swing gate
will remain locked. All the other doors can
be unlocked from inside your vehicle by
pressing the unlock button located at the
front part of the front inner handles. Doors
can be unlocked individually by pulling the
interior door handles on those doors.
If the front passenger door is the first door
which is unlocked, all the doors will be
unlocked.
Disabled Keys
Any keys left inside your vehicle interior
when it is locked will be disabled.
You cannot use a disabled key to switch
the ignition on or start the engine.
You must enable all Intelligent Access
again in order to use them.
To enable all your Intelligent Access,
unlock your vehicle using a passive key or
the remote control unlocking function.
All Intelligent Access will then be enabled
if you switch the ignition on or your
vehicle is started using a valid key.
Intelligent Access - Locking and
Unlocking the Doors with the Key
Blade (If Equipped)
A. Push the release button and pull the
key blade out.
B. Remove the key blade and insert it into
the lock.
Note:
Only the driver door handle has a
lock
cylinder.
A
B
34
Territory (CF4) Philippines, Vehicles Built From: 25-05-2020, EN, First Printing
To Next Page
Loading...
