Ford THUNDERBIRD 1960 - Page 200

PART
7-I - REAR AXLE TROUBLE SHOOTING AND MINOR
REPAIRS 7-S
aged in any
manner, install a new
seal.
16, On a manual-shift transmis
sion, lubricate the yoke spline with
B6A-19580-A
or
-B.
On
a
Cruise
0-Marie transmission, lubricate
the
yoke spline with B8A-19589-A. This
spline is sealed so that the transmis
sion
fluid does not ‘wash" away the
spline lubricant Fig. 6. Install the
yoke on the
transmission output
SNAP RING WRAP TYPEI
El 173-A
shaft.
FIG. 6-output Shaft Spline Seal
17. Install the
U-bolts and nuts
whichattach
the U-joint to the
drive
pinion flange.
14. Use the same procedure
to 15. If the rubber bellows-type
remove and replace the rear
U-joint seal installed on the end of the trans-
18. Grease the front and rear U
spider
and
bearings,
mission extension
housing is dam-
joint
with general chassis grease.