Ford TOURNEO CONNECT 2015 - Page 87

Programming the Time Functions
Set the time you want your vehicle to be
warm and ready to drive. Use the
information display controls on the
steering wheel. See Information
Displays (page 66).
1. Select the desired days you want the
system to warm up your vehicle.
Highlight each desired day and press
the OK button.
2. Highlight the time at the top of the
menu and press the OK button. The
hours will flash.
3. Set the hours using the up and down
arrow buttons.
4. Press the right arrow button. The
minutes will flash. Set the minutes
using the up and down arrow buttons.
Press the OK button.
Programming the Once Function
Selecting this function allows you to
program one heating cycle for one specific
day.
Set the time you want your vehicle to be
warm and ready to drive. Use the
information display controls on the
steering wheel. See Information
Displays (page 66).
1. Highlight the time at the top of the
menu and press the OK button. The
hours start to flash.
2. Set the hours using the up and down
arrow buttons.
3. Press the right arrow button. Set the
minutes using the up and down arrow
buttons. Press the OK button.
Switching Programmed Functions Off
Use the information display controls on
the steering wheel. See Information
Displays (page 66).
To switch the programmed functions off, scroll to:
Action and DescriptionMessage
Press the OK button.Settings
Press the OK button.Convenience
Press the OK button.Park heater
Select one of the following:
Uncheck the active programmed heating cycles as required.Time 1
Uncheck the active programmed heating cycles as required.Time 2
Uncheck the active programmed heating cycles as required.Once
85
Tourneo Connect (CHC) Vehicles Built From: 10-03-2014, Vehicles Built Up To: 31-12-2014, Long Wheelbase Kombi/Short Wheelbase Kombi, Base/Base High Payload/Titanium/Titanium High Payload/Trend/Trend ECOlite/Trend High Payload, CG3588en enGBR, Edition date: 02/2014, None
Climate Control