3. Release the securing rod from the
bra
cket and push the rod firmly into the
seat anchoring until the securing rod
engages → Fig. 72.
Folding seat back
1. Unhook the rod from the seat anchoring
point.
2. Secure the rod in the retainer under the
seat.
3. Fold the complete seat back until it en-
gages.
4. Fold back the backrest → page 101.
WARNING
Injuries could be caused if the seats are
folded forwards and b
ackwards careless-
ly.
·
The seat must always be supported by
the rod when folded forwards.
NOTICE
Improper folding of the seats can cause
damage to the seats.
·
Close the drink holder between the front
seats before folding the two-seat bench
forwards.
Removing and installing seats in
the sec
ond row
Please refer to , and at the
s
tart of the chapter on page 100.
Fig. 73 S
econd row of seats: Removing the
two-seat bench.
Fig. 74 S
econd row of seats: Removing the
two-seat bench.
Fig. 75 S
econd row of seats: Installing the
two-seat bench.
The seats in the second row are divided in-
to a single seat and a two-seat bench. The
seat and the bench seat can be removed
separately to increase the size of the load
compartment.
Removing the seat
1. Fold the backrest forwards → page 101.
2. Fold the seat forwards → page 103.
3.
Pull the rods → Fig. 73
1 in the direction
of the arrow until both locking marks
→ Fig. 7
4
2 are in the red area.
T
he seat is released.
4. Use the carry grips to remove the seat
by liing it out of the catch
3 .
Fit
ting the seat
1. Fit seat in the retainers.
104
Seats and head restraints
To Next Page
Loading...
