2.
P
ress the rods → Fig. 75
1 downwards
in the direc
tion of the arrow until both
locking marks
2 are in the green area.
T
he seat is locked in position.
3. Fold the seat back → page 103.
4. Fold back the backrest → page 101.
WARNING
Injuries could be caused if the seats are
removed and installed c
arelessly.
·
The lock indicator shows the seat is se-
curely engaged . The seat is not secure-
ly engaged if at least one of the lock in-
dicators is in the red area. Always check
that both lock indicators are in the
green area when the seat is installed.
Folding the backrest of the third
row of seats forwards and back-
wards
Please refer to , and at the
s
tart of the chapter on page 100.
Fig. 76 Third row of seats: Folding backrests
forwards.
1
release lever.
2
Loop.
Folding the backrest forwards
1.
Push the head restraint all the way
down → Fig. 76 (arrows).
2.
Pull the release lever
1 fully to the rear
to relea
se the backrest.
3. Guide the backrest down by hand.
Do not transport any pa
ssengers (adults or
children) on the seat with a folded-down
backrest in the third row.
Folding the backrest backwards
1.
Pull the loop
2 on the backrest to fold
the sea
t backwards.
Or: Fold the backrest back by hand
from the vehicle interior.
2. Aer pushing back, check that the
backrest has engaged securely. The red
marking on the release lever
1 must no
longer be visible → .
3.
Adjust the head restraint → page 47.
WARNING
An insecure backrest can cause severe in-
juries.
·
A red marking on the relea
se lever indi-
cates that the backrest is not engaged.
Always make sure that the red mark is
never visible when the seat backrest is
in the upright position.
Removing and t
ting seats in the
third row of seats
Please refer to , and at the
s
tart of the chapter on page 100.
Fig. 77 T
hird row of seats: Removing the
seats.
Rear seats
105
2KF012720AE
To Next Page
Loading...
