— With oncoming tra
c on streets with
a central barrier where the driver can see
clearly over the central barrier e.g. truck
drivers.
— In fog, snow or heavy rain.
— In dusty or sandy areas.
— Damage to the windscreen in the area of
the camera window.
— If the camera window is misted up, dirty,
covered by a sticker, snow or ice.
— If the camera is broken or the power sup-
ply is interrupted.
WARNING
Automatic Main Beam Control may not
be able to rec
ognise all driving situations
correctly and may not work properly in
certain situations. Automatic Main Beam
Control only provides support; the driver is
responsible for making sure the vehicle
lights are switched on correctly. Incorrect
use of the high beam headlamps can dis-
tract and dazzle other road users. This
could cause accidents and serious or fatal
injuries.
·
Always check the lighting yourself and
adjust it to suit the light, visibility and
trac conditions.
·
Switch o high beam manually if other
road users could be dazzled.
WARNING
If the camera window is dirty, covered or
dama
ged, the function of Automatic Main
Beam Control may be impaired. This also
applies if changes are made to the vehi-
cle’s lighting system, for example if addi-
tional headlamps are fitted. This could
cause accidents and serious or fatal inju-
ries.
·
Clean the camera window at regular in-
tervals, and keep it clean and free from
snow and ice.
·
Do not cover the camera window.
·
Check the windscreen in the area of the
camera window for damage at regular
intervals.
Troubleshooting
Indicator lamp for direction in-
dic
ator
The indicator lamp fla
shes green.
If a direction indicator on the vehicle has
failed, the indicator lamp will start flashing
twice as fast.
1. Check the lighting and change the ap-
propriate bulb as required → page 309.
2. If the fault persists, go to a suitably
qualified workshop.
Indicator lamp for trailer direction
indic
ator
The indicator lamp fla
shes green.
The indicator lamp goes out if a trailer di-
rection indicator or all trailer lights stop
working.
1. Check the lighting and change the ap-
propriate bulb as required → page 309.
2. If the fault persists, go to a suitably
qualified workshop.
Exterior drive lighting not working
The indicator lamp lights up yellow.
E
xterior drive lighting not working partially
or completely.
1. Check the lighting and change the ap-
propriate bulb as required → page 309.
2. If the fault persists, go to a suitably
qualified workshop.
Fault in rain and light sensor
In light switch position
, the vehicle
lighting is not switched on or o automati-
cally.
1. Switch the ignition on and o.
2. If the fault persists, go to a suitably
qualified workshop.
In cold or damp weather, condensa-
tion may build up briefly on the interior
of the headlamps, tail lamps and direction
indicators. This is normal and does not af-
fect the service life of the lighting system of
your vehicle.
Vehicle lighting 113
2KF012720AE
To Next Page
Loading...
