Ford TOURNEO CONNECT 2024 - Page 118

Deactivating the Coming Home func-
tion
1. Automatically aer the set switch-o
delay has elapsed.
Or: automatically if a vehicle door or
the boot lid is still open approximately
30 seconds aer switch-on.
Or: press the light switch as oen as
necessary until the setting
is dis-
pla
yed in the instrument cluster.
Or: switch on the ignition.
Activating the Leaving Home function
1. Unlock the vehicle when automatic
lighting control
is switched on and
the light sensor detec
ts darkness.
Deactivating the Leaving Home func-
tion
1. Automatically aer the switch-o de-
lay.
Or: lock the vehicle.
Or: press the light switch as oen as
necessary until the setting
is dis-
pla
yed in the instrument cluster.
Or: switch on the ignition.
Light functions
Static cornering light
W
hen the low beam head lamps are
switched on, a cornering light is switched
on when turning slowly or driving around
very tight bends.
When reverse gear is engaged, the
cornering light on both sides of the ve-
hicle switches on to provide better illumi-
nation of the surrounding area when ma-
noeuvring.
Automatic lighting control
W
hen the automatic lighting control
is
switched on, the vehicle lighting and the in-
strument and switch lighting will switch on
under the following c
onditions:
— The light sensor has detected darkness.
—
The windscreen wipers have been
switched on for an extended period.
When the lights are switched on, the indi-
cator lamp
lights up yellow
→ pa
ge 110.
The automatic lighting control is merely an
aid and will not always be able to detect all
driving situations.
In vehicles with a corresponding equipment
level, the switch-on time of the automatic
headlights can be set in the vehicle settings
in the Infotainment system → page 34.
Headlight range control
Hea
dlight range control can be used to ad-
just the low beam light cone to the vehicle
load level. This gives the driver the best vis-
ibility possible and means that oncoming
trac will not be dazzled →
.
T
he headlight range can be adjusted in the
Infotainment system, depending on the
equipment.
Manual headlight range control
Adjusting in the Infotainment system:
1. Tap the
Vehicle
function button.
2.
Tap the
Headlights
function button.
3.
Tap the
Headlight
range control
function
button.
4
. Tap the required setting value (typical
vehicle load level).
Settings in the
Infotainment
system
Front seats occupied and
loa
d compartment emp-
ty.
All seats occupied and
loa
d compartment emp-
ty.
All seats occupied and
loa
d compartment fully
laden.
Towing a trailer with a low
drawbar load.
116 Lights