Ford TOURNEO CONNECT 2024 - Page 174

speed limiter has the following additional,
system-rela
ted limits:
— The predictive speed limiter detects only
trac signs that show a speed limit.
— Trac signs that indicate a speed limit in-
directly, e.g. place-name signs, will be
detected only on the basis of the naviga-
tion data.
— If a speed limit is announced on the basis
of the navigation data but is not detected
by the Trac Sign Recognition function,
the announced speed will be reset to the
last-stored speed.
— The predictive speed limiter is not availa-
ble for detected speed limits below
around 30 km/h (around 20 mph). A cor-
responding text message is shown on the
instrument cluster display in this case.
Joining and leaving motorways
— When you join a motorway, the recom-
mended speed or permitted maximum
speed will automatically be stored as the
speed, depending on country.
— The predictive speed limiter will be deac-
tivated when you leave the motorway.
Function limitations
In the following situations, it is possible
that the predictive speed limiter will not
change the stored speed or will change it
with a delay or in an unexpected way:
— There is a fault in the Trac Sign Recog-
nition system.
— The navigation data is out-of-date.
— You are driving without route guidance.
— You leave the route calculated by the
navigation system.
— The vehicle position cannot be deter-
mined correctly due to imprecise GPS
data.
Activating the predictive speed
limit
er
Please refer to at the start of the
chapt
er on page 171.
1. Open the Assist systems menu in the
Infotainment system.
2. Select the Speed Limiter.
3. Switch on the reaction to the permitted
speed.
4. Switch on the Speed Limiter and start
control → page 170.
Driving with the predictive speed
limit
er
Please refer to at the start of the
chapt
er on page 171.
Displays
The system has detected a speed
limit on the route.
The system has stored the detected
speed limit and performs c
ontrol in-
terventions accordingly.
Cancelling speed adaptation
If you do not want to adopt an announced
speed, you can cancel speed adaptation:
— Press the
button.
Or: if the announced speed is lower than
the currently saved speed, release the
accelerator twice and press again.
The last-stored speed is resumed again.
— Press the
button.
T
he current speed is adopted.
— Press the
button.
S
ystem control is interrupted.
Bringing forward speed adaptation
As soon as a higher speed than the current-
ly stored speed is announced in the instru-
ment cluster display, you can bring forward
speed adaptation:
— Press the
button.
172 Driver assist systems