Ford TOURNEO CONNECT 2024 - Page 30

Operating the digital instrument
cl
uster
Fig. 13 Right side of the multifunc
tion steer-
ing wheel: operating the digital instrument
cluster (illustration).
If any priority 1 warnings are displayed, you
will be unable to open any menus
→ page 21, Warning and information mes-
sages. You can confirm and hide some
warnings using the
button on the mul-
tifunc
tion steering wheel → Fig. 13.
Adjusting views in the display area
You can manually adjust the views for
speedometer, rev counter or driver assis-
tance systems in the display area.
1. Press the
button on the multifunc-
tion steering wheel.
C
entral display of the round in-
strument views for speedometer or
rev counter.
Central display of the driver assis-
tance systems view.
A display with information on the ve-
hicle status, e.g. total mileage, is
shown before starting and aer switching
o the engine.
Selecting secondary displays
1. Select the right or le secondary dis-
play area with the
or button.
2.
Select the desired secondary display
with the arrow buttons
and .
3. C
onfirm the selection with the
but-
ton.
Classic
Modern
Showing or hiding secondary displays
1. Hold down the button.
C
onguring secondary displays
You can configure the secondary displays
according to your preferences in order to
select which secondary displays are availa-
ble in the secondary display area:
1. Select the right or le secondary dis-
play area with the
or button.
2.
Use the arrow buttons
and to nav-
iga
te to the Settings menu and open
this menu.
3. Press the
button to make your
changes.
A tick indicates that the correspond-
ing sec
ondary display is activated.
4. To return to menu selection, press
the
or button.
T
he secondary displays can be config-
ured or hidden independently of each
other.
If warning messages about malfunc-
tions are displayed when the ignition
is switched on, it may not be possible to
adjust some settings or display information
as described. If the fault persists, go to
a suitably qualified workshop.
WARNING
Operating the instrument cluster and In-
fotainment system c
an distract you from
the road. If the driver is distracted when
driving, this can cause accidents and seri-
ous or fatal injuries.
·
Always drive with your full attention
and responsibly.
·
Never operate the instrument cluster
while the vehicle is in motion.
·
Adjust all settings in the instrument
cluster and Infotainment system only
when the vehicle is stationary.
28 Driver information