Ford TOURNEO CONNECT 2024 - Changing Lights

Changing the wiper blade for the rear
window
Fig. 178 A
t the rear of the vehicle: Changing
the wiper blade for the rear window.
1
Release button.
1. Li the wiper arm and fold it a
way,
making sure that you hold it only in the
area of the wiper blade mounting.
2. Press and hold the release button
→ Fig. 178
1 .
3.
Tilt the wiper blade in the direction of
the wiper arm → Fig. 178
A and pull it
o in the direc
tion of the arrow
B at the
same time. Y
ou may need to use some
force to do this.
4. Insert a new wiper blade with the same
length and design onto the wiper arm in
the opposite direction of the arrow
→ Fig. 178
B and push it on until it en-
ga
ges. The wiper blade must be in fol-
ded-down position to do this
A .
5.
Carefully place the wiper arm back onto
the rear window.
Changing lights
Introduction
Before changing bulb
s, check whether
a bulb or LED light unit has failed. It is nor-
mally possible for you to change bulbs
yourself. If the exterior lighting is designed
using LED technology, depending on the
vehicle model and equipment, it may not
be possible for you to change LED light
units or individual LEDs yourself. Failure of
individual LEDs can be an indication that
other LEDs may fail. In this case, have the
light units checked and renewed if nec
es-
sary at a suitably qualified workshop.
A box with the replacement bulbs necessa-
ry for trac safety should always be carried
in the vehicle. Replacement bulbs are avail-
able from a suitably qualified workshop. In
some countries it is a legal requirement to
carry these replacement bulbs.
It may be illegal to drive with defective
lights of the exterior lighting.
1. Before changing bulbs, check whether
a bulb or LED light unit is installed.
Additional bulb specication
Some bulbs in the headlamps or tail lamp
clusters may have certain factory specifica-
tions that deviate from conventional bulbs.
The designation is inscribed on the bulb, ei-
ther on the glass part or on the base.
WARNING
If the vehicle lighting is not switched on
a
ccording to the weather conditions, the
road will not be illuminated suciently.
Other road users may then have diculty
seeing the vehicle or may not see it at all.
This could cause accidents and serious or
fatal injuries.
·
Check the lighting system and the di-
rection indicators of the vehicle regular-
ly.
·
Have the lighting system repaired im-
mediately if necessary.
WARNING
When working in the bonnet space, acci-
dents and serious injuries c
an be caused
as a result of bulb changes that are not
performed correctly.
·
Always follow the described actions
and observe the general safety precau-
tions.
·
Never change bulbs unless you know
exactly how to do it.
·
If you are uncertain about how to
change a bulb, have the work carried
out by a suitably qualified workshop.
Changing lights 309
2KF012720AE