Replacing bulbs in the headlamps
Please refer to and at the start
of the chapt
er on page 309.
Preparations
The steps should be carried out in the given
order only:
1. Observe the information on changing
bulbs and carry out the work steps.
2. Open the bonnet.
It is not necessary to remove the headlamp
to change a bulb.
The illustrations show the right-hand
headlamp. The le-hand headlamp is
a mirror image of the one shown.
There are various types of headlamp,
so the position and design of covers,
bulbs and bulb holders may vary from
those shown in the illustrations.
For daytime running lights designed
using LED technology, it is not possi-
ble to replace the LEDs. Go to a suitably
qualified workshop.
Fig. 179 In the bonnet spa
ce: covers on back
of the right-hand headlamp.
1
Cap for high beam headlamp and day-
time running light.
2
Cap for low beam headlamp.
3
Cap for direction indicator.
Fig. 180 In the bonnet spa
ce: replacing
bulbs in the right-hand headlamp.
1
Bulb for high beam headlamp and day-
time running light.
2
Bulb for low beam headlamp.
3
Bulb for direction indicator.
Replacing high beam and daytime run-
ning light bulbs
1. Pull o rubber cover from back of head-
lamp → Fig. 179 1 .
2.
Turn the bulb holder in the direction of
the arrow as far as it will go and pull it
out to the rear → Fig. 180
1 .
3.
Replace the defective bulb with a new
bulb of the same type. If applicable,
push the catch on the bulb holder and
pull the bulb straight out of the bulb
holder.
4. Insert the bulb holder into the head-
lamp and turn it in the opposite direc-
tion to the arrow as far as it will go
→ Fig. 180
1 .
5.
Fit the rubber cover onto the rear of the
headlamp → Fig. 179
1 .
6
. Close the bonnet.
Replacing bulbs in the low beam head-
lamp
1. Pull o rubber cover from back of head-
lamp → Fig. 179
2 .
2.
Pull out the bulb holder in the direction
of the arrow → Fig. 180
2 .
Changing lights 311
2KF012720AE
To Next Page
Loading...
