Replacing the bulb
Fig. 182 On the tail lamp cluster: disc
on-
necting the connector.
1
connector.
Fig. 183 On the tail lamp cluster: removing
the bulb holder.
1
Securing bolt.
1. Pull o the c
onnector in the direction of
the arrow → Fig. 182
1 .
2.
Undo three securing screws with the
screwdriver → Fig. 183
1 . Insert a suita-
ble interchangeable bla
de if necessary.
3. Remove the bulb holder → Fig. 183.
4. Replace defective bulbs with a new
bulb of the same type.
Fitting the tail lamp cluster
1. Carefully insert the bulb holder into the
tail lamp cluster → Fig. 183.
2. Screw the bulb holder onto the tail
lamp cluster with the three securing
screws → Fig. 183
1 .
3.
Check that the bulb holder is fitted cor-
rectly and is securely seated.
4. Plug the connector onto the bulb holder
→ Fig. 182
1 .
5.
Insert the tail lamp cluster into the
opening in the body and carefully press
into the holder → Fig. 181.
6. Tighten the securing screws
→ Fig. 181
1 .
7
. Check that the tail lamp cluster is fitted
correctly and is securely seated.
8. Close the boot lid or rear doors.
Replacing the direction indicator
r
epeater bulb
Please refer to and at the start
of the chapt
er on page 309.
Fig. 184 On the side of the vehicle: removing
the direc
tion indicator repeater.
Changing lights
313
2KF012720AE
To Next Page
Loading...
