per limit of this range, e.g. when the en-
gine is working hard → pa
ge 332,
→ page 333. Continue to step 8 or 16.
C Engine oil level is too low. Where ap-
plic
able, follow any messages that are
shown on the instrument cluster dis-
play and make sure you add engine oil.
Continue to step 8.
8. Aer reading o the engine oil level,
push the oil dipstick back into the guide
tube as far as it will go.
9. Unscrew the engine oil filler opening
cap → Fig. 206.
10. Gradually add engine oil in small quan-
tities, no more than 0.5 l (0.5 qt) in to-
tal, or follow the recommendation in
the instrument cluster. The use of ap-
proved engine oils in accordance with
the relevant standard is recommended.
11. In order to avoid overfilling, wait for at
least 1 minute aer each refill step to
allow the engine oil to flow into the oil
sump up to the marking on the engine
oil dipstick.
12. Read the engine oil level from the dip-
stick again before refilling with a further
small quantity of engine oil. Never over-
fill with engine oil →
.
13. A
er filling, the engine oil level should
be in the middle of the area
→ Fig. 205
B . The engine oil level must
not be in area → Fig. 205 A → .
1
4. If too much engine oil has been added
unintentionally and the engine oil level
is in area → Fig. 205
A , do not start the
engine. S
eek expert assistance.
15. Aer refilling, screw the engine oil filler
cap back on.
16. Insert the oil dipstick into the guide tube
as far as it will go. If there is a marking
on the upper end of the oil dipstick, this
marking must fit in the corresponding
groove at the top end of the guide tube
when inserting.
17. Close the bonnet
→ pa
ge 328.
WARNING
When adding engine oil, the engine oil can
run out or overflow and ignite if it c
omes
into contact with parts of the engine that
are hot or can become hot. This can cause
fires or burns. T
his can result in serious or
fatal injuries.
·
Always ensure that the engine oil filler
cap is securely tightened aer refilling,
and that the dipstick is properly inser-
ted back into the guide tube.
·
Always use a suitable filling aid when
adding engine oil.
NOTICE
If the engine oil level is too high a
er top-
ping up and the engine is started, this can
damage the engine.
·
Do not start the engine and seek quali-
fied professional assistance.
NOTICE
The use of incorrect service fluids could re-
sult in serious malfunctions and engine
damage.
·
When refilling service fluids, ensure that
you pour the correct service fluids into
the correct openings.
Troubleshooting
Please refer to , and on page
326 and at the start of the chapter on
pa
ge 332.
Engine oil pressure too low
The warning lamp flashes red. A message
is shown on the instrument cluster display.
Do not drive on! The engine could oth-
erwise be damaged.
1. Stop the vehicle as soon as possible
and when safe to do so.
2. Switch o the engine.
3. Check the engine oil level → page 334.
4. Do not drive on or leave the engine run-
ning if the warning lamp is flashing even
when the engine oil level is correct. The
engine could otherwise be damaged.
Seek expert assistance.
Engine oil 335
2KF012720AE
To Next Page
Loading...
