Since start memory
T
he memory collects travel and fuel econo-
my data from the moment the ignition is
switched on until it is switched o. The
memory will be deleted if the trip is inter-
rupted for more than two hours.
Long-term memory
The memory collects the driving values for
a driving time of up to 100 hours or a dis-
tance covered of 999 km (mi). The memo-
ry is deleted if one of these maximum val-
ues is exceeded.
Since refuelling memory
Display and storage of the collected driving
and fuel economy values. The memory is
deleted when the tank is refilled
Resetting driving data displays in the
instrument cluster
1. Press the
or button.
2.
Using the arrow buttons
or , select
the desired driving da
ta display in the
configuration menu.
An arrow aer the entry in the configu-
ration menu indicates that a submenu
is available.
3. Select Reset data in the submenu and
confirm with the
button.
R
esetting the trip recorder
1. Touch the Vehicle function button in
the Infotainment system.
2. In the Vehicle menu, touch the Status
function button.
3. Tap the Distance covered function but-
ton.
4. Tap the
0.0
function button to reset the
value.
AdBlue range or Range
Approximate calculation of the distance in
km (miles) tha
t the vehicle can still travel
with the current AdBlue® level if the same
driving style is maintained. If it is possible to
increase the range by refilling, the required
refill quantity is also displayed.
WARNING
If the driver is distracted when driving, this
c
an cause accidents and serious injuries.
Operating the instrument cluster and In-
fotainment system can distract you from
the road.
·
Always drive with your full attention
and responsibly.
·
Never operate the instrument cluster
while the vehicle is in motion.
·
Adjust all settings in the instrument
cluster and Infotainment system only
when the vehicle is stationary.
Service
Service menu
Settings can be made in the Service menu
depending on the vehicle equipment.
Opening the Service menu
1. Select the Driving time/Distance cov-
ered information profile in the secon-
dary displays.
2. Depending on the selected secondary
display area, press and hold the or
button on the multifunction steering
wheel for around 6 sec
onds.
3. Navigate in the menu using the arrow
buttons
and .
Opening the servic
e interval status
1. Select the Service menu in the service
menu.
An overview of the remaining distance
and days until the next maintenance or
oil change service is shown in the in-
strument cluster display.
Resetting maintenance
1. Select the Reset maintenance menu.
2. Observe the instructions on the instru-
ment cluster display.
Resetting oil change service
1. Select the Reset oil service menu.
32
Driver information
To Next Page
Loading...
