·
S
eek immediate medical assistance if
you suspect that someone has swal-
lowed a button cell.
·
Always keep the remote control and
key ring with button cells out of the
reach of children.
NOTICE
The vehicle key may be damaged if the
button c
ell is not replaced correctly or if an
unsuitable battery is used.
·
Replace a discharged battery only with
a new battery of the same voltage rating,
size and specification.
·
Pay attention to the correct polarity
when inserting the battery.
·
Do not use the remote control if you can-
not close the battery cover.
The type of batteries used in the re-
mote c
ontrol of your vehicle key may
contain perchlorate. This may require spe-
cial handling. Please observe all the legal
requirements regarding the handling and
disposal of these batteries. We recommend
that you have this service carried out by
a qualified workshop.
Synchronising the vehicle key
If you c
annot lock or unlock the vehicle with
the vehicle key, synchronise the vehicle key
or replace the button cell → page 79.
Synchronising the vehicle key:
1. Stand beside the vehicle.
2. Press the button on the vehicle key
twice in quick succession.
Or:
1. Fold the key bit out of the vehicle key, or
remove the spare key → pa
ge 78.
2. Press the
button on the vehicle key.
3.
Unlock the vehicle with the spare key or
with the key bit on the vehicle key.
4. Open le-hand front door. If the vehicle
has an anti-the alarm, this will be trig-
gered immediately → page 89.
5. Switch on the ignition.
6. Or: pla
ce the vehicle key in the rear
drink holder in the centre console.
The synchronisation process is complete.
Troubleshooting
C
annot lock or unlock vehicle.
One or more doors not closed.
1. Close all doors.
Or: The sensor in the vehicle key is faulty.
1. Check whether the sensor of the vehicle
key is subject to interference, such as
from obstacles or transmitters close to
the vehicle.
2. Synchronise the vehicle key → page 80.
Or: The button cell in the vehicle key is dis-
charged.
1. Replace the button cell → page 79.
Or: Lock or unlock the vehicle using the
lock cylinder in the le front door
→ page 84. When the vehicle has an
anti-the alarm this will be triggered
immediately.
2. Switch on the ignition and unlock the
vehicle with the central locking button
→ page 85.
Or: the central locking system has switch-
ed itself o temporarily to protect the sys-
tem against overloading.
1. Lock or unlock the doors manually
→ page 84.
2. Lock or unlock the boot lid manually
→ page 91.
3. If the fault persists, the system should
be checked by a suitably qualified
workshop.
The indicator lamp in the vehicle key is
not working.
1. Change the button cell in the vehicle
key → page 79.
The 12-volt vehicle battery is dis-
charged.
1. Unlock the vehicle using the lock cylin-
der in the le front door → page 84.
80 Opening and closing
To Next Page
Loading...
