EasyManua.ls Logo

Ford TOURNEO CONNECT 2024 - Page 85

Ford TOURNEO CONNECT 2024
467 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1. Clean the sensors.
A
ll direction indicators ash four times
The vehicle key used last is still in the vehi-
cle.
1. Remove the vehicle key and lock the
vehicle.
Automatic sensor switch-o
The sensors will be disabled in the follow-
ing circumstances:
If the vehicle is not locked or unlocked for
an extended period.
If a sensor is touched too many times.
Reactivating the sensors:
1. Unlock the vehicle with the
button in
the vehicle key.
NOTICE
Please note that the sensors in the door
handles c
an be activated by a powerful jet
of water or steam if a valid vehicle key is si-
multaneously within its operating range.
The windows could open as a result and
moisture could enter the vehicle interior.
This could lead to the vehicle interior being
damaged.
·
Never direct the jet of a high-pressure or
steam cleaner directly at the sensors in
the door handles.
If at least one window is open and
sensor surfa
ces on the door handles
are continuously activated, all windows will
close.
There may be a malfunction in the
Keyless Entry system if the message
Error. Keyless Entry system appears on the
instrument cluster display. Go to a qualified
workshop.
If there is no vehicle key in the vehicle
or if it is not detected, a message will
be shown on the instrument cluster display.
This may occur if the vehicle key is subject
to interference from another radio signal or
is covered by an object, e.g. an aluminium
case.
Doors and central locking but-
t
on
Introduction
If the vehicle key or central locking fails, the
doors can be locked manually and, in some
cases, also unlocked manually.
The central locking system enables you to
centrally lock and unlock all the doors, the
boot lid and the tank flap of the vehicle.
The vehicle can only be locked with the ve-
hicle key if the ignition has been switched
o or the driver has switched o the engine
before leaving the vehicle.
Always take the vehicle key with you when
you leave the vehicle.
A symbol in the instrument cluster display
indicates if one or more doors or lids are
not closed properly .
Do not drive on!
1.
Park the vehicle safely if necessary.
2. Open the door in question and then
close it again.
This symbol is also visible when the ignition
is switched o and will go out a few sec-
onds aer the vehicle has been locked
when all doors and lids are closed.
WARNING
Any door that is not properly closed could
open suddenly while the vehicle is in mo-
tion. T
his could lead to severe injuries.
·
Stop immediately and close the door.
·
Make sure that the door is closed prop-
erly and that the lock has engaged. The
closed door must be flush with the sur-
rounding body panels.
·
Open or close the doors only when
there is no-one in the movement path
of the boot lid.
WARNING
Any door being held open by the door ar-
rester c
ould close unexpectedly in strong
winds or if the vehicle is on a slope. This
could lead to serious injuries.
·
Always hold the door handle firmly
when opening and closing doors.
Doors and central locking button 83
2KF012720AE

Table of Contents

Related product manuals