Troubleshooting
Please refer to and at the start
of the chapt
er on page 83.
The red LED in the driver door lights up
continuously
The red LED for the central locking system
in the driver door flashes at short intervals
and then lights up continuously.
There is a fault in the locking system.
1. Go to a suitably qualified workshop and
have the system checked.
Direction indicators do not ash when
locking
The direction indicators do not flash to con-
firm that the vehicle has been locked.
1. Close all windows and doors.
2. Close the boot lid.
3. If the direction indicators still do not
flash, go to a suitably qualified work-
shop to have the system checked.
Response when locking the vehicle
with a second vehicle key
Keyless Entry: any vehicle key located inside
the vehicle will be blocked from starting
the engine if the vehicle has been locked
from the outside using a second vehicle
key.
1. Press the
button on the key inside
the vehicle so tha
t it can then be used
to start the engine → page 146.
Locking the vehicle aer airbags have
been triggered
The entire vehicle is unlocked if the airbags
are activated during an accident. Depend-
ing on the extent of the damage, the vehi-
cle can be locked as follows aer an acci-
dent:
1. Switch o the ignition.
2. Remove the vehicle key from the igni-
tion lock.
3. Open and close any vehicle door.
4. Lock the vehicle using the vehicle key.
Or: press the central locking button in
the driver door → page 78.
It is no longer possible to lock the sliding
doors a
er an airbag has been triggered.
Consult a suitably qualified workshop to re-
store the locking function.
Automatic deactivation of the sensors
The sensors will be disabled in the follow-
ing circumstances:
— The vehicle is not unlocked or locked for
an extended period.
— A sensor has been triggered an excessive
number of times.
Reactivating the sensors:
1. Unlock the vehicle with the
button in
the vehicle key.
NOTICE
Please note that the sensors in the door
handles c
an be activated by a powerful jet
of water or steam if a valid vehicle key is si-
multaneously within its operating range.
The windows could open as a result and
moisture could enter the vehicle interior.
This could lead to the vehicle interior being
damaged.
·
Never direct the jet of a high-pressure or
steam cleaner directly at the sensors in
the door handles.
It may not be possible to lock or un-
lock the vehicle using K
eyless Entry if
the 12-volt vehicle battery or button cell in
the vehicle key is weak or discharged. The
vehicle can be locked or unlocked manually
→ page 83.
If there is no valid vehicle key in the
vehicle or if it is not detected, a corre-
sponding display will be shown on the in-
strument cluster display. This may occur if
the vehicle key is disrupted by another ra-
dio signal or is covered by another item
such as an aluminium suitcase
→ page 146.
Anti-the alarm
Depending on the vehicle equipment level,
the vehicle may have an anti-the alarm.
Anti-the alarm 89
2KF012720AE
To Next Page
Loading...
